STRYM 800 direct flow reverse osmosis 120lt./h. with electronic faucet

Strym 800 is a high-performance RO System, with a compact design and incredibly easy to use and maintain.

Flow rate
Up to 2 liters per minute (it depends on the water temperature, the inlet pressure and the water salinity).

High efficiency
The device produces the 65% of treated water and it discharges just the 35%.

Filtration
Filter 1: just one filter which includes the pre-filtration (PP+BLOCK) + the post-filtration (GAC).
Filter 2: 800 GPD RO membrane.

Start-up
The start-up is automatic and you even don't need to open the device; it will flush out the Carbon GAC of the post-filter (it release little quantity of carbon and the water quickly becomes transparent).

Maintenance
Simple and there is no need to open the system.
Just close the inlet water, empty the system from water and pressure and replace the filter.

Smart faucet (see fig.1)
The let ring on the faucet shows the water quality and the status of the filters.
A. Steady blue led
The water quality is excellent.
B. Flashing blue led
Automatic flushing of the device.
C. Steady orange led
Exhausted filters; replace them urgently.
D. Flashing orange led
Almost exhausted filters.

Frontal let interface
The LED placed on the frontal panel, warns you about the status of the filter and/or the Ro Membrane, the eater quality and any possible anomalies.

Flushing
Automatic flushings to protect the membrane's life.

Without TDS mixing valve.

Features:
- Pump: booster pump 24V.
- Rated voltage: 230V-50 Hz
- Rated power: 90W.
- Work pressure (min.- max.): 0,4-0,9 MPa (4-9 bar)
- Inlet pressure (min.- max.): 0,1-0,4 MPa (1-4 bar)
- Inlet temperature (min.- max.): 5-38 ºC
- Inlet TDS (max): 1500 ppm
- Hardness (max): 15ºHF
- Adaptor: 100-240 Vac 50/60 Hz: 24 5 A

The reverse osmosis is not a device that makes water drinkable(non-drinkable water into drinkable water) and it work only if it's installed on water compliant with the law, municipal potable water or well water if previously made drinkable with adequate and effective systems, preventively studied and personalized for that kind of water.
Do not use the system where the water is microbiologically dangerous or of unknown quality without adequate disinfection before and after the system. All systems must be preserved according to the producer instructions.
The pollutant parts removed or reduced by this system are not necessarily in your water.
In case of potable inlet water of bad quality, it's possible to close all the outgoing mineral salts regulator (TDS) and to mount, as the last stage, a remineralizer filter that stabilizes the Ph.
1x Ionicore remineralizer PH adjustment coconut in line filter (GAC) 1/4" FPT 2"x10".